FAA Proposes Mandatory Bearing Inspections on Certain Boeing 737 MAX Aircraft

1033
0



Editorial photo credit: miglagoa – stock.adobe.com

The FAA has proposed a mandatory airworthiness directive targeting certain Boeing 737 MAX 8, MAX 9, and MAX 8-200 aircraft over improperly installed bearings in the elevator control system. The proposal was published September 21 and covers 95 U.S.-registered aircraft, though additional airplanes on foreign registries may also be affected.

The issue centers on the elevator buss assembly — the mechanical linkage between the pilots’ control columns and the elevators that govern pitch. According to the FAA, some bearings in that assembly may have been installed during production without required sealant. The defect can cause cracks in the bearings and their housings, leading to premature failure of the elevator buss assembly crank arms. The FAA stated the condition, if not corrected, could affect elevator pitch control and continued safe flight and landing.

Boeing first identified the production problem and issued Alert Requirements Bulletin 737-27A1331 RB on December 17, 2025. The FAA subsequently determined the unsafe condition is likely to exist or develop across other aircraft of the same type design.

Not every 737 MAX is subject to the proposal. Applicability is limited to specific aircraft Boeing identified in that requirements bulletin.

Under the proposed directive, operators would inspect the affected bearings and housings for cracks and verify sealant application. Depending on findings, corrective action could range from load testing and individual bearing replacement to full replacement of the elevator buss assembly.

The FAA estimates each initial inspection at 23 work hours and roughly $1,955 per aircraft — $185,725 across the 95 U.S.-registered airplanes combined. If corrective work is required, costs climb sharply. Individual bearing replacement runs between $1,105 and $1,809 per component. A full elevator buss assembly replacement is estimated at approximately $98,500 per aircraft. The FAA noted it cannot project how many aircraft will require repairs, and some or all costs may be covered under Boeing warranty.

For maintenance teams, this is a significant labor ask if the inspections scale to a large portion of the fleet. The 23-hour initial inspection figure per airplane, multiplied across affected aircraft at a carrier operating multiple MAX variants, represents meaningful hangar time and scheduling coordination.

The directive is not yet final. The FAA is accepting public comments through November 5, and requirements could change before a final airworthiness directive is issued.

This site uses Akismet to reduce spam. Learn how your comment data is processed.